Push pull tent activity shed - there are advantages you don't know
Time：2025-12-11
Push pull tent activity shed - there are advantages you may not know.
The wind resistance performance of the commonly used sliding canopy material in the past was significantly unsatisfactory, and it was more dangerous in strong wind weather. For example, the push pull tent activity shed cannot withstand strong winds; Organic glass sliding canopy activity shed is a brittle material that is prone to breakage; The sturdy stainless steel sliding canopy has a problem of loud noise during rainy weather; Canvas sliding canopy activity shed is prone to loss, everyone must have heard of it. Until the emergence of PC endurance boards, people gradually realized that using endurance boards as the main material for push-pull canopy activity sheds could effectively solve wind resistance and noise problems.
PC board has become the preferred specialized material for rain shelters. So why has PC board become a professional material for push-pull tent activity sheds? Today, the editor will show you that PC durable boards have become the preferred choice for sliding awnings.
1、 Installation instructions for the push-pull tent activity shed.
Due to the toughness of the board, the PC endurance board installed under external force will bend. Increasing the embedded size inside the frame can avoid bending. In the event of impact, the PC endurance board may detach from the frame. In this case, you can choose to increase the embedding depth, replace it with a thick plate, or fix it with screws.
2. Due to the high coefficient of thermal expansion, thermal expansion space should be reserved within the frame. If there is not enough thermal expansion space, the thickness of the board can be increased and the embedded part can be reduced.
3. Choose the appropriate plate thickness based on the load.
2、 Precautions for installing a sliding canopy activity shed.
When the cement surface of a new building is not dry, the PC durable board cannot come into direct contact.
2. PC durable board can be cold-formed, and its minimum bending radius should meet the following conditions:
3. Outdoor use: The bending radius shall not be less than 180 times the thickness of the board.
4. Use a soft cloth or sponge dipped in neutral soap or detergent to scrub the dust and dirt on the surface of the PC endurance board, then rinse thoroughly with water, and finally wipe dry with a soft cloth.
5. If there is grease, unfinished paint, adhesive marks, etc. on the board surface. It is recommended to use a soft cloth dipped in anhydrous alcohol to scrub. Before embedding the PC durable board into the frame, the protective film on the embedded part should be lifted.
3、 Installation accessories for push-pull tent activity shed.
Aluminum alloy or steel plastic bracket: used for installing durable sun visors on both sides (usually 80cm)
Common colors for aluminum brackets: black, white, champagne, gray.
Common colors for plastic steel brackets: black, white, gray.
Conventional thickness: 2.5mm
Conventional thickness: 6mm
Conventional dimensions of the board: elongation of 60.80.100.120.150cm, width should not exceed 120cm as much as possible
Common colors of the board: transparent, lake blue, brown, grass green, milky white, etc. If it is opaque, you can also choose a frosted board. The connection between the board and the bracket requires waterproof adhesive tape.
